Sbc self support tool alerts

Not a member yet? It is an older software version which can be operated only on certain now no longer commercially available products. English German. Product Index. General FAQ Welcome to the support site If you know our products and are looking for technical information you are at the right place here.

Connection of PCD controllers directly to the Internet Reduce the risk of potential intruders in automation systems. Last changes to this site. Information about the Log4j vulnerabilities Tuesday, This service pack contains one correction of PG5 2.

For a list of the licenses that are required for Direct Routing, see the "Licensing and other requirements" section of Plan Direct Routing. If the SBC certificate is self-signed, it is not valid. To download the certificate, see Microsoft encryption chains.

Then, install it on the SBC. Sometimes, even if everything looks correct, a closer examination of the packet capture might reveal that the TLS certificate is not provided to the Teams infrastructure. The TLS connection may have been closed by one of the intermediary devices such as a firewall or a router on the path between the SBC and the Microsoft network.

Check for any connection issues within your managed network, and fix them. Still need help? Go to Microsoft Community. Skip to main content. This browser is no longer supported. Privacy policy. This is step 1 of the following steps to configure Direct Routing:. For example, if you have two domain names, contoso. If using a subdomain, make sure this subdomain is also registered in your tenant. For example, if you want to use sbc. Configure the following settings for the SBC, based on your organization's needs.

For details on each of these settings, see SBC settings. After you establish a remote PowerShell session, verify that you can see the commands to manage the SBC. To verify the commands, type or copy and paste the following command in the PowerShell session, and then press Enter:.

In a PowerShell session, type the following, and then press Enter:. This example shows only the minimum required parameters. To learn more, see SBC settings.

Type the following in a remote PowerShell session, and then press Enter:. The paired gateway should appear in the list as shown in the example below, and the Enabled parameter should display a value of True.

Skip to main content. This browser is no longer supported. Download Microsoft Edge More info.